LQM-IV Gas Thermal Oil Heater

Main technical parameters

☑ Design thermal efficiency     95%

☑ Operation temperature       ＜320℃

☑ Heat transfer medium     Organic heat carrier (thermal oil)

☑ Furnace structure      Horizontal, triple return

☑ Furnace coil specifications  DN50×3mm，Three rows

☑ Furnace body size       Φ1350×2400mm

☑ Operation mode       Liquid phase/auxiliary circulation

☑ Load regulation     25～100%Continuing Adjust

☑ Control method       PLC+frequency conversion (reserved RS485 communication interface, RJ45 connector)

☑Waste heat utilization method             Air Preheating

☑ Design pressure     0.8mpa

☑ Operating pressure      0.3～0.4mpa

☑ Oil outlet/return diameter   DN100（Pipe flange standard HG/T20615，PN16）

☑ Applicable fuel       Natural gas (PNG), liquefied gas (LNG), petroleum gas (LPG)

☑ Gas caliber      DN40

☑ Gas pressure      6～8kpa（dynamic pressure）

☑ Inlet direction      Default lower right front end (please indicate left intake)

☑Exhaust gas temperature     ～100℃（Exhaust gas temperature）

☑ Nitrogen oxide concentration   Low nitrogen type＜50mg/Nm³

☑ Host oil capacity    ～390kg

☑ Equipped with a circulating pump    11/15kw（Optional specifications; Single/dual pumps are optional）

☑ Installed capacity      15/19kw

☑ Appearance coating      Overall spray coating, default medium gray+white (other colors can be specified)

☑ Factory form       skid-mounted

☑ Weight       ～3800kg

☑ Expansion tank size   Φ=800mm，L=1200mm，V=650L