LQM-III Gas Thermal Oil Heater

Main technical parameters

☑ Design thermal efficiency     95%

☑ Operation temperature      ＜320℃

☑ Heat transfer medium      Organic heat carrier (thermal oil)

☑ Furnace structure       Horizontal, triple return

☑ Furnace coil specifications  DN50×3mm，Double row

☑ Furnace body size       Φ1200×2100mm

☑ Operation mode      Liquid phase/auxiliary circulation

☑ Load regulation      25～100%Continuing Adjust

☑ Control method      PLC+Variable frequency (reserved RS485 communication interface, RJ45 connector)

☑ Waste heat utilization method   Air Preheating

☑ Design pressure      0.8mpa

☑ Operating pressure      0.3～0.4mpa

☑ Oil outlet/return diameter  DN80(Pipe flange standard HG/T20615, PN16)

☑ Applicable fuel       Natural gas (PNG), liquefied gas (LNG), petroleum gas (LPG)

☑ Gas caliber       DN40

☑ Gas pressure      6～8kpa(Dynamic pressure)

☑ Inlet direction      Default lower right front end (please indicate left intake)

☑ Exhaust gas temperature      ～100℃（Change with oil temperature）

☑ Nitrogen oxide concentration   Low nitrogen type＜50mg/Nm³

☑ Host oil capacity    ～325kg

☑ Equipped with a circulating pump    7.5/11kw（Optional specifications; Single/dual pumps are optional）

☑ Installed capacity       12/15kw

☑ Appearance coating      Overall spray coating, default medium gray+white (other colors can be specified)

☑ Factory form       Skid-mounted

☑ Weight       ～3250kg

☑ Expansion tank size    Φ=600mm，L=1000mm，V=300L