LQM-II Gas Thermal Oil Heater

Main technical parameters

☑ Design thermal efficiency     95%

☑ Operation temperature       ＜320℃

☑ Heat transfer medium      Organic heat carrier (thermal oil)

☑ Furnace structure       Horizontal, triple return

☑ Furnace coil specifications   DN40×3mm，Double row

☑ Furnace body size       Φ1100×1900mm

☑ Operation mode      Liquid phase/auxiliary circulation

☑ Load regulation      25～100%Continuing Adjust

☑ Control method      PLC+Variable frequency (reserved RS485 communication interface, RJ45 connector)

☑ Waste heat utilization method: air preheating

☑Design pressure      0.8mpa

☑ Operating pressure      0.3～0.4mpa

☑ Oil outlet/return diameter  DN65（Pipe flange standard HG/T20615，PN16）

☑ Applicable fuel      Natural gas (PNG), liquefied gas (LNG), petroleum gas (LPG)

☑ Gas caliber      DN25

☑ Gas pressure       6～8kpa（dynamic pressure）

☑ Inlet direction       Default lower right front end (please indicate left intake)

☑ Exhaust gas temperature       ～100℃（Change with oil temperature）

☑ Nitrogen oxide concentration   Low nitrogen type＜50mg/Nm³

☑ Host oil capacity     ～250kg

☑ Equipped with a circulating pump     5.5/7.5kw（Optional specifications; Single/dual pumps are optional）

☑ Installed capacity      8/10kw

☑ Appearance coating       Overall spray coating, default medium gray+white (other colors can be specified)

☑ Factory form      skid-mounted

☑ Weight      ～2400kg

☑ Expansion tank size    Φ=600mm，L=800mm，V=250L